The replacement/ spare part for Wanhao D7, and other 3D Printers

Fan 6010 - 12V -0.4A - Dual Ball Bearing

The high-quality replacement gives much more air than the regular fan. The Dual Ball Bearing construction makes it much more reliable. 

• Cut all wires except red (+) and black (-) from the fan
• Remove the connector from the fan
• Strip the end of the wires bare
• Connect to the printer control board, and make sure to check the polarity

• You can use the red and black wires from the old fan
• Remove the connector (and unused wires) from the new fan
• Connect the wires black on black, red on red
• Solder or use a luster terminal to permanently secure the old wires to the wires of the new fan
• Make sure you use isolation tape on any bare wires/connections

Note 

• Due to the changes that manufacturers do in the 3D printers, before buying check if the part is compatible with the version of your 3D printer
• If you have a question about the spare part contact us

Warranty

• Please visit Terms and Conditions page
• If you have any questions do not hesitate to contact us