Bestseller!Henkel/Loctite 3D Cleaner C – 1KG

Henkel/Loctite 3D Cleaner C is a non-flammable cleaner for post-processing 3D printed models. Cleaner C has an ambient temperature with a flashpoint of 75°C and was designed to effectively clean small details such as 1mm, deep tubes, or complex structural parts. Compared to the IPA alcohol, Cleaner C is not only no-flammable but also does not harm 3D-printed models during the washing process. Cleaner C can be used for longer wash cycles and is water rinseable. 

• cleans effectively difficult parts - like lattice structures
• non-flammable - compared to IPA alcohol is much safer to use
• high cleaning performance
• water rinseable
• safe for the environment
• does not damage "green" or cured parts when used as recommended
• effectively solubilizes 3D printed resins like Loctite 3D 3840 

Technical Specification

• Viscosity at 20°C: 14cP
• Flashpoint: 75°C
• Flammable: NO
• Appearance: Clear Liquid
• Capacity: 1KG

Note

• Cleaner C is NOT recommended for silicone-based materials such as Loctite 3D 5015 and 5010
• Use at 20-50°C and  immerse for 2-4 minutes intervals with adequate mixing
• Rinse with clean DI water for 1-2 minutes with agitation, optionally rinse with IPA if stated on material TDS
• Provide adequate drying time prior to UV curing (Typical 60 minutes at 20-25°C)
• Works perfect with Ultrasonic Cleaner

Warranty

• Please visit Terms and Conditions page
• If you have any questions do not hesitate to contact us